nedis FSBS120AT Guide De Démarrage Rapide page 5

2. Plug the other end of the micro USB cable B 1 into a USB power
adapter to charge the product.
The charging indicator LED B 4 lights up red when charging.
4
The charging indicator LED B 4 stops lighting up when charging
4
is complete.
Pair with one speaker
1. Hold the power button A 2 for 2 seconds to switch on the
product.
The Bluetooth indicator LED A 3 starts flashing to indicate pairing
4
mode is active.
2. Activate Bluetooth on your audio source and connect with the
product (FSBS120).
3. If asked, enter the pairing code '0000' .
The Bluetooth indicator LED A 3 lights up to indicate successful
4
pairing.
Pair with both speakers
1. Hold the power button A 2 on both speakers for 2 seconds to
switch them on.
After a few seconds, one of the two speakers emits a tone to
4
indicate that it is paired with the other speaker.
The Bluetooth indicator LED A 3 lights up on of the speakers to
4
indicate it is ready to pair with an audio source.
If pairing between the speakers fails, double press the power
4
button A 2 to retry.
2. Activate Bluetooth on your audio source and connect with the
product (FSBS120).
If the speakers are correctly paired to eachother, only one of them
4
emits a Bluetooth signal. In case you see two signals, retry pairing
the speakers to eachother.
3. If asked, enter the pairing code '0000' .
Connect with audio cable (Image B)
Audio cable is not included.
4
To pair the audio source to the product using an audio cable, follow
these steps:
BS120AT_MAN_COMP_(19705 1422)_v1.0.indd 5
5
24-10-2019 11:51:4