nedis DCAM40BK Guide De Démarrage Rapide page 8

Installing the product (image B)
Before using the product, the user shall check the applicable laws and
regulations on the use of the product.
In some jurisdictions, the use of this product can be considered as an invasion
of privacy.
The mounting of the product on the windshield might be regulated by law in
some jurisdictions.
It is the user's own responsibility to consult the local laws and regulations
before installing and using this product.
4
Switch off the car engine.
1. Clean and degrease the spot where you want to fix the product.
4
Place the product just behind or below the rearview mirror.
2. Place suction fix A
3. Use the suction fix clip A
4. Insert a microSD card (not included) into the microSD card slot A
5. Adjust the position of the front camera A
6. Adjust the position of the cabin camera A
4
Ensure the product and the power cable are installed and do not interfere
with the sight of the driver or impede with the operation of any driving
controls.
4
Always focus your attention on the road.
Connecting the product to a power source
Option 1:
1. Plug the other end of the auxiliary power plug A
3
A
.
9
2. Plug A
into an auxiliary power outlet.
Option 2:
1. Charge the product using the USB port A
4
The product automatically switches on and starts recording when you switch
on your car engine.
4
The recording time can be set in the menu with the range of 3, 5 or 10
minutes.
4
The camera switches off after the engine is off.
Using the product
1. Press power button A
4
When switching off the product automatically saves the recordings.
2
on the windshield.
1
to fix the product to the windshield.
t
for 3 seconds to switch the product on or off.
5
for optimal view of the road.
w
for optimal view of the inside.
9
into the micro USB port
2
.
8
4
.