Use - Imetec GK818 Mode D'emploi

WARNING! DO NOT use this appliance if
there are visible signs of damage.
WARNING! DO NOT use the appliance if
the blades are damaged or do not work
properly.
Make sure that your beard or hair is dry and clean, with no residue of
hairspray, mousse, gel or other hair products, and then brush in the
direction of growth, untangling any knots.
WARNING! Switch the appliance off
before changing any accessories.
CONNECTING/DISCONNECTING THE ACCESSORIES
• To connect an attachment: hold the appliance in one hand, position
the desired head and push it down with force until you hear a "click".
• To disconnect an attachment: press the central part of the head
upwards using your thumb, then remove it from the appliance.
TRIMMING YOUR BEARD
• Connect the precision comb with the appliance turned off.
• Using the U-blade head: Set the comb (10 or 11) to the desired
trimming length.
• Using the T-blade head: Choose and connect one of the four combs
provided (12/13/14/15).
• It is recommended to clean the blade and comb with the provided
brush (21) after each use to prevent the accumulation of residual hair.
• To adjust the cutting length further, use the micro precision button (4).

USE

24
EN