AEG MRC 4140 I Mode D'emploi page 98

English
98
Troubleshooting
Problem
Device cannot
be operated.
Alarm sound not
audible.
No audio signal
during playback
via induction
function.
Interfering noise
during music
playback via in-
duction function.
Possible cause
Device blocked or
"frozen".
Switch on the back
is set to the "SPK"
position.
Switch on the back
is set to the "FM"
position.
Audio source is not
aligned with the
correct position on
the device.
Induction function
switched off.
Battery voltage too
low.
Audio source
features a metal
housing.
Solution
Disconnect the mains
adapter from the wall
socket for approx.
5 seconds. Then switch
the device on again.
Set the switch to the
"FM" position.
Set the switch to the
"SPK" position.
Change the position of
the audio source. Make
sure to place the built-
in speaker of your audio
source on position (5) of
the device.
Press the button (6) until
the indicator lamp (4)
lights up.
Insert new batteries or
use the mains adapter
provided.
Use an audio source
without metal housing.