PCM KSC-310-II Mode D'emploi page 2

English
1. To fix the tool holder on the machine,
introduce the shank and use the pin for
positioning. Tighten the 3 fixing screws
(important, make sure that the screws
have the same clamping force).
2. Adjust the offsets of the 3 positions
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
KSC-310-II
3. During the mounting or the dismounting
of your tools, block the broach on flats
planned for that purpose, using an
adapted wrench.
4. The
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
MARK :
empty positions. Use the supplied
protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
KSC-310-II 1-. Mode
RBT
Validation : 04.06.13
tool shank diameter should never
Never use the tool holder with
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email: office@pcm.ch
Document :
d'emploi
Page : 2 de 4