Perel OBH5 Mode D'emploi page 5

5.2 Use
Refer to the illustrations on page 2 of this manual.
1. Open the lever on the extension tube connector [D] and move the extension tube [F] up or down to adjust
to the desired height. Close the lever to lock the position.
2. Open the clamp assembly [A] until the clamp jaws accommodate the bicycle's top tube, frame post or seat
post. Use the lever on top of the clamp assembly [A] to lock the clamp onto the tube. To avoid damage to
your bicycle, do not overtighten.
3. Remove the bicycle from the clamp assembly [A] in the reverse order.
4. The clamp can be rotated 360° allowing easy access to any parts of the bicycle.
5. To adjust the angle of the clamp, slightly loosen the knob located on the other side of the clamp. After
adjusting the angle, fasten the knob again.
Warning: To avoid unintentional angle change, make sure the knob is always fastened.
6. Cleaning and Maintenance
The bicycle work stand does not need any particular maintenance. However, occasionally wipe it with a damp
cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong detergents.
7. Technical Specifications
height
maximum load
materials
stand
clip
tool rack
colour
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.perel.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 08/07/2015
OBH5
110-143 cm
30 kg
Q195-grade steel
nylon
PP
black and grey
6.8 kg
5 ©Velleman nv