User Manual - Perel OBH5 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or to
a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel. Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions

Observe all safety instructions to avoid damages due to improper use. Follow all warnings on the product.

Keep this manual for future reference. Should this product be passed on to a third party, this manual must
be included as well.

No liability will be accepted for damages resulting from improper use or non-compliance with these
instructions.

Do not allow children to climb on or play near this product.

Inspect the product before using it. Do not use it if you spot any bent, broken or cracked parts.

Always remove the bicycle when making adjustments to the working height. Do not set the height beyond
its maximum position.

Some bicycle manufacturers recommend not clamping thin-walled or carbon fibre frames. Consult your
bicycle's manufacturer to find out the suggested clamping locations.

To avoid damages to the bicycle, clean the frame tube before clamping.

The clamp can be rotated 360°, allowing easy access to any parts of the bicycle. Remove the bicycle before
adjusting the clamp angle.

Both clamping jaws have a recess to provide clearance for cables. Make sure any brake of shift cables are in
one of the recesses before clamping, so as to avoid damages to the bicycle.

If the saddle or other parts of the bicycle interfere with the rotation of the cam handle, reverse the clamp
so that the cam handle faces the opposite direction.

This bicycle stand is intended to support bicycles for repairing tasks and storage. Do not use it for other
purposes. Any other use might lead to personal injury or damage to goods.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4. Parts Overview
Refer to the illustrations on page 2 of this manual.
A 1x clamp assembly
B 1x tool tray holder
C 1x tool tray
D 1x extension tube connector
E 1x yoke
5. Operation
5.1 Assembly
Refer to the illustrations on page 2 of this manual.
V. 01 – 08/07/2015
OBH5

USER MANUAL

F
G
H
I
J
4
1x extension tube
2x legs with caps on one end
1x leg with caps on both ends
1x upright tube
screws and nuts
©Velleman nv