Tips For Use; Maintenance And Service - Varan QL1000i Manuel D'instructions

English
- If the machine switched to the generator has a
higher consumption rate than that of the generator,
the on pilot will turn to red and will cut the
electricity supply to protect the generator.
- If this happens stop the and disconnect the
machine from the mains and investigate the cause
of the overcharge. After two minutes connect the
generator again.
7.2. VERIFICATION POINTS AFTER COMMISSIONING
Check that the noise of the machine is normal and
that it does not vibrate. If you detect any anomaly
in the machine stop immediately. In case of any
malfunction or problem take the machine in for
service to be repaired. In no circumstance should you
continue to use the machine if the operation does not
seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.

7.3. TIPS FOR USE

- If you are connecting two or more devices to the
generator, connect them one by one starting with
the one using the most power.
- Remember that most of the devices require
more power than specified in the label to boot. It
could happen that this generator, although capable
of supporting the consumption of the appliance in
operation, cannot generate the energy needed for
its start-up.
- If you use this generator to give power to a
circuit of a house have the operation performed
by a qualified electrician. Inadequate connections
between the generator and the home appliances
could lead to severe damage to the generator and
to the connected devices or lead to fire.

8. MAINTENANCE AND SERVICE

Before performing any maintenance on
the machine or repair make sure that
engine has stopped and remove the spark
plug pipe. Perform all machine maintenance with the
machine placed on a flat, clear surface.
Never attempt adjustments on the machine if it is
running. Perform all machine maintenance while it is
placed on a flat, clear surface.
WARNING! Do not modify the machine. Any
inadequate use of these elements can cause SERIOUS
PERSONAL HARM OR DEATH.
Use only replacements suitable for this machine in
order to obtain a proper performance of the machine.
These replacements can be found in the official
distributors of the machine. The use of other spare
parts can cause accidental damage to the user and
people around machine.
Do not adjust the carburetor. If necessary take
your machine in for service. Carburetor adjustment is
complicated and only the technical service must do so.
An incorrect setting of the carburetor may cause
damage to the engine and will be cause for
cancellation of the guarantee.
The removal of security devices, improper
maintenance, and replacement of elements with non-
original spare parts can cause injury.
Perform regular inspections on the machine in order
to ensure efficient operation of the machine.
For complete service, we recommend to take the
machine to your technical service provider.
Perform maintenance frequently as indicated in the
following table:
34/108