Kimpex CLICK N GO 2 Instructions D'assemblage page 7

"CLICK N GO 2" PLOW ATTACHMENT
Polaris RZR 900
8) Assemble four (4) M8-1.25 x 25 mm carriage bolts
and one (1) M8-1.25 x 20 mm hex. bolt
V-plate using five (5) M8-1.25 hex. nuts
A
the first threads only, except the M8-1.25 x 20 mm
hex. bolt , which must be fully tightened. See
E
Figure 6.
E
C
A
C
Fig. 6
9) Assemble the V-plate
by first aligning the rear carriage bolts, then the
front carriage bolts . See Figure 7.
C
Fig. 7
10) Once the M8-1.25 x 25 mm carriage bolts
inserted to the bottom of the oblong holes of the
attachment plate , tighten all bolts in place.
01
Position of the Push Frame Hook Assembly
Install the push frame hook assembly in Position 3. Refer
to the instructions of the push frame for the assembly
procedure.
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
2810526  A-2810526  Printed in Canada
ASSEMBLY INSTRUCTIONS
on the
E
. Screw
D
on the attachment plate
A
are
C
C
01
374402
KIMPEX NO.
3