Connecting To A Network; Checking The Installation - Hewlett Packard HP 10BT/100TX NIGHTDIRECTOR/100 Guide D'installation

book.bk : chapter.fb Page 11 Monday, October 13, 1997 6:08 PM
Remote Wake Up
(RWU) and Remote
Power On (RPO)
All manuals and user guides at all-guides.com

Connecting to a Network

Connect the network cable to the RJ-45 UTP (Unshielded Twisted
Pair) LAN connector. The LAN card supports both 10 Mbits/s and
100 Mbits/s operation.
10BT/100TX
Connector
The HP LAN card has the ability to power up the PC upon receipt of a
special sequence (known as a Magic Packet
The RWU mode allows the PC to resume normal functioning when it is
in sleep (suspend) mode.
The RPO mode allows the PC to start when it is switched off.

Checking the Installation

Test whether the HP LAN card functions on the network by finding
another network device or performing a network operation. If it does
not work correctly, refer to "Troubleshooting" on page 12.
19
1 Installing the HP LAN Card
Connecting to a Network
TM
) from the network.
English 11