Post-Installation Procedure; Post-Installation On A Windows 95 System; Post-Installation On A Windows Nt 4.0 System - Hewlett Packard HP 10BT/100TX NIGHTDIRECTOR/100 Guide D'installation

book.bk : chapter.fb Page 10 Monday, October 13, 1997 6:08 PM
CAUTION
CAUTION
All manuals and user guides at all-guides.com
1 Installing the HP LAN Card

Post-installation Procedure

Post-installation Procedure
Make sure that you have installed the HP LAN card before you perform
the post-installation step.

Post-installation on a Windows 95 System

1 Restart the PC. Windows 95 automatically detects, and installs the
software for, the HP LAN card. You may be asked to insert one of the
Windows 95 installation diskettes.
2 Restart your PC when prompted to do so. Remember to remove the
HP LAN Setup diskette before you do this.
The HP LAN card is now ready to use.

Post-installation on a Windows NT 4.0 System

1 Restart the PC and start Windows. You do not need to
press +
2 When prompted to do so, insert the HP LAN Setup diskette into the
diskette drive, and click OK. The setup wizard starts, and displays a
dialog box indicating that the PC is ready to install the HP LAN card.
3 Type the path to the NT master disk (C:\I386 if the operating system
files were copied to the hard disk during the installation of Windows
NT), then click Next. The installation of the HP LAN card starts
automatically. When the installation is complete, the last page of the
wizard is displayed.
4 Click Finish to end the wizard.
5 Restart your PC when prompted to do so. Remember to remove the
HP LAN Setup diskette before you do this.
If a service pack was already installed on the PC before the HP LAN card
was installed, the service pack must be re-installed before the HP LAN
card will function.
The HP LAN card is now ready to use.
10 English
+ to log on.
18