Publicité
Les langues disponibles
Les langues disponibles
Capacity : 6kg-180kg
Precision (division) : 100g
1
x 1
The lower and upper stand pole are identical.
Batteries required: 4 x 1.5V AAA (not included)
Before assembling the scale, please insert the batteries at the back of the platform.
1
Position the tip of your finger on
the long black groove. Then press
and push the battery cover as
illustrated above.
4
Position the battery cover so that
its center tab (figure above) and its
2 tabs located on each side (see
figure
5)
insert
into
corresponding holes.
2 persons may be required for the mounting.
Firstly, unpack and put all the scale parts, listed in section: "Description of parts", on the floor and
proceed as below:
FEATURES
DESCRIPTION OF PARTS
2
Lower stand pole *
x 1
BATTERY INSTALLATION
Remove the cover.
their
MOUNTING
2
Low battery and overload indication
Selection of unit weight: kg/lb/st:lb
3
Pole
Upper stand pole*
connector x 1
2
5
English
4
LCD displayx 1
x 1
3
Insert the batteries. Make sure to
follow the polarity indicated inside
the battery compartment.
6
Push downward to lock the
battery cover.
5
Publicité
