Beem DYNAMIC i-POWER Mode D'emploi page 27

EN
Use the measuring cup (17) to fill
‹
the tank (12) up to the "MAX" mark
(fig. D). The tank capacity is approxi-
mately 0.35 litres.
Close the lid of the tank (2).
‹
Move the iron horizontally back and
‹
forwards for approximately 30 sec-
onds; in this way, the water is cleaned
by the anti-calcification system of the
appliance.
Steam ironing
If necessary, fill the appliance with wa-
‹
ter (Filling with water section).
During heating up, make sure that
‹
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light ups.
Set the temperature regulator (13)
‹
― according to the care label of the
fabric to be ironed ― between the me-
dium (●●) and maximum temperature.
Effective steam ironing is possible
within this range.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Wait until the appliance has heated
‹
up, the control indicator (11) flashes
and the temperature indicators extin-
guish.
Set the desired steam flow with the
‹
steam flow regulator (3).
BEEM - Elements of Lifestyle
DYNAMIC i-POWER
Upright steam ironing
NOTE
► Upright steam ironing is suitable for
hanging textiles (coats, suits, cur-
tains) and for removing creases.
► Only hang the washing to be ironed
where heat and humidity cannot
cause damage, NOT in front of
wallpaper, windows or mirrors for
example.
► The appliance produces turbo steam
for upright steam ironing. This has a
separate pipe and is only discharged
from the front part of the ironing sole.
If necessary, fill the appliance with wa-
‹
ter (Filling with water section).
During heating up, make sure that
‹
the appliance is placed upright on an
even surface.
Insert the plug of the appliance into
‹
the mains socket. The control indica-
tor (11) light ups.
Turn the temperature regulator (13) to
‹
the "MAX" position.
The temperature indicators (9) light up
on both sides of the appliance during
heat-up.
Hold the appliance upright with a gap
‹
of 5 to 15 cm in front of the fabric to
be ironed and press the steam shot
button (4) every 2 to 5 seconds.
Move the ironing sole up and down in
front of the fabric.
If steam is no longer discharged, wait
‹
for a few seconds until the appliance
produces new steam.
.
23