Bosch Sensixx DS38 Notice D'utilisation page 19

4. "PulseSteam" function

See the leaflet sides
This appliance has a special function for
tackling difficult creases.
When the steam release button is activated, the
steam generator will release three powerful shots
of steam so that the steam reaches even deeper
into the fabrics.
Briefly press the steam shot button (15*) on the
top of the handle.
Remarks:
• It is possible to stop the shots of steam by
quickly pressing the steam button again.
• Some water drops may appear when you use
the "PulseSteam" function for the first time.
The water drops will disappear after you have
used the function for some time.
5. "Intelligent steam" function
This system has intelligent steam control, which,
after releasing the steam release button (14 or 15*),
provides a small amount of additional steam.
The additional steam can always be stopped by
briefly pressing the steam release button once
again.
6. Ironing without steam
Begin ironing but without pressing the steam
release button (14 or 15*).
7. Vertical steam

See the leaflet sides
This can be used to remove creases from
hanging clothes, curtains etc.
Warning!:
E
Never direct the steam jet at garments
that are being worn.
Never aim the steam at people or animals.
1. Select "Jeans / • • •" programme to get the
optimal steam amount.
2. Hold the iron in an upright position 15 cm away
from the garment being steamed.
* Model dependent
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing
the iron in a vertical position and pressing the
steam release button (14 or 15*).
8. Energy saving "eco" button
Push the energy saving button
If the energy saving setting is selected, you can
save up to 30% of the energy and 40% of the
water consumption (*), and still achieve good
results when ironing most of your garments.
It is advisable to use the normal energy setting
only for thick and very wrinkled fabrics.
(*) In comparison to the maximum setting.
9. Auto shut-off
If during ironing, the steam release button
(14 or 15*) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The illuminated ring around the programme
selector (9) will flash when auto shut-off has been
activated. Three beeps will be heard at the same
time.
To switch the steam station back on, press the
steam release button again.
10. Fabric protection
soleplate cover
TextileProtect

See the leaflet sides
The fabric-protection soleplate cover (18*) is used
for steam-ironing delicate garments at maximum
temperature without damaging them. Use of the
soleplate cover also does away with the need for a
cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place the
tip of the iron into the end of the soleplate cover
and pull the elastic strap over the lower rear of the
iron until it fits tightly. To release the soleplate
cover, pull the elastic strap and remove the iron.
The fabric-protection soleplate cover may be
purchased from our customer service or from our
website.
(6).
19
BOS CH