Use; Assembly Instructions; Programming - Cuisinart DGB900BCE Mode D'emploi

1 13 14 15

3. USE

A. ASSEMBLY INSTRUCTIONS
Before you use the machine for the first time, or when it has not
been used for some time, fill the water reservoir with cold water
to the maximum level (without coffee or filter), deactivate the
coffee grinder (push the 'Grind Off' button), put the carafe in
position and run a full cycle.
1. Inserting the water filter
• Remove the filter from the plastic packing and soak in cold
water for 15 minutes.
• Rinse the filter under running water for 10 seconds. Then
allow the filter to drain completely.
• The filter compartment is to the left of the water reservoir.
Open the compartment, pull out the filter basket, insert the
filter, slide the filter basket into the bottom of the water
reservoir and close.
• We recommend the filter be changed about every 60 uses.
10
Programme
16 17 18 19
2. Rinsing the carafe
• Remove the coffee pot lid by turning it in the direction indi-
cated.
3. Placing a coffee filter in the filter basket
• Open the filter compartment and insert the permanent filter.
• Then place the lid on top and close the compartment.
CAUTION! The unit can only operate if the coffee grinder covers
and the filter basket door are closed firmly. A beep will sound
and the unit will stop operating, if it is on, when one of the
covers is open or if opened before the end of the cycle. The beep
will stop as soon as the cover is closed. To turn the machine on,
push the ON button.
B. PROGRAMMING
1. Setting the time
• When the unit is plugged in, the screen will show 1:00.
• Press and hold either the 'Hour' or the 'Min' button until the
numbers start to flash.
• Then press the 'Hour' and 'Min' buttons to scroll through the
numbers. When the numbers stop flashing, the time has
been set.
CAUTION! When you go past the number 1, the letters 'PM' will
appear to adjust the time from 1 noon to midnight. When 'PM'
is not shown, the time indicated corresponds to the AM hours,
from 1 midnight to 1 noon. Always make sure that the time
is set according the correct period so that the programming is
correct.
2. Programming the start time
• Press and hold the 'PROG' button. The numbers and the
indicator light will flash.
• To set the desired start time, press the 'Hour' and 'Min' but-
tons as described for setting the time. When the numbers
stop flashing, the scheduled time is programmed.
CAUTION! You will not be able to program the start time while
the coffee machine is running.