Before The First Use; Contents Of Packing; Intended Use; Nail / Staples Selection - Batavia MAXXPACK BT-CSN001 Mode D'emploi

ation of the nails. In such cases, always
make sure that there is no one (and
nobody's hands or feet; etc.) behind the
thin board or next to the wood you are
going to nail.
Simultaneous nailing on both sides of
2.20
the same wall is dangerous. Under no
circumstances should nailing be per-
formed on both sides of a wall at the
same time. This would be very danger-
ous since the nails might pass through
the wall and thus cause injuries.
Do not use the power tool on scaffold-
2.21
ings, ladders. The power tool shall not
be used for specific application for
example:
– when changing one driving location to
another involves the use of scaffold-
ings, stairs, ladders or ladder alike con-
structions, e.g. roof laths,
– closing boxes or crates,
– fitting transportation safety systems
e.g. on vehicles and wagons.
Remove all remaining fasteners and
2.22
battery from nailer when:
– doing maintenance and inspection;
– checking proper operation of push lever
and trigger;
– attaching or removing the nose cap;
– clearing a jam;
– it is not in use;
– leaving work area;
– moving it to another location; and
– handing it to another person.
– Never attempt to clear a jam or repair
the Nailer unless you have removed
battery and all remaining fasteners
from the Nailer. The Nailer should never
be left unattended since people who are
not familiar with the Nailer might handle
it and injure the themselves.
Remove battery from nailer when:
2.23
a. loading nails;
b. turning the adjuster.
The operating environment for this
2.24
device is between 0 °C and 40 °C so
ensure use within this temperature
range. The device may fail to operate
below 0 °C or above 40 °C.
Do not allow foreign matter to enter the
2.25
hole for connecting the rechargeable
battery.
NEVER allow magnets (or similar mag-
2.26
netic devices) to be adjacent to the
nailer, because the nailer has a mag-
netic sensor inside. Doing so will cause
a failure or risk of injury by malfunction.
Resting the unit after continuous work.
2.27
The power tool is equipped with a tem-
2.28
perature protection circuit to protect the
motor. Continuous work may cause the
temperature of the unit to rise, activat-
ing the temperature protection circuit
and automatically stopping operation. If
this happens, allow the power tool to
cool before resuming use.
This product may cease to operate
2.29
when an abnormality is detected.
Do not give a strong shock to the switch
2.30
panel or break it. It may lead to a
trouble.

3. Before the first use

Remove the machine and all accessories
from the package. Keep the packaging
materials out of the reach of small children.
There is a danger of suffocation!

4. Contents of packing

1× Cordless stapler / nailer
1× Instruction manual

5. Intended use

This tool was designed for driving nails into
wood and similar materials. Use it for its
intended purpose only.
Metal and materials containing asbestos
must not be worked with this tool.

6. Nail / staples selection

(See Fig. B)
• Nails:
• Staples:

7. Loading nails / staples

Only use recommended nails / staples.
Non-recommended nails / staples are more
likely to jam in the nil gun.
Release the battery (3) from the nail
7.1
gun.
English
max. length 50 mm.
max. length 40 mm.
7