Publicité
Les langues disponibles
Les langues disponibles
2. Insert a Micro SD Card
(maximum 32 GB).
3. Insert the power supply into
the DC connector and a wall
outlet. Switch the power to
ON. The power and detect
indicator light up.
4. For operation of the motion detection function (or use the remote control), push the
detect button to activate the motion detection function. The indicator will flash a few
times and then go out. When motion is detected the standby indicator flashes once. To
end the function push the detect button again. The standby indicator will light up again.
Two beeps will indicate that the function is activated. One beep indicates the function is
deactivated.
5. The different functions can also be operated by remote control.
A. Start manual recording (motion detection is
disabled and the motion detector will record
constantly until the stop button is pressed)
B. Stop manual recording
C. Enable motion detection
D. Disable motion detection
Note: the remote control has infrared
transmission, which means you have to point
the remote control towards the clock for
operation.
6. The clock starts to record 3 seconds before motion is detected and 15 seconds after the
last detection with a minimum of 18 seconds of recording. When motion is continually
detected the motion detector will recording constantly. The recording time of any single
file should not exceed 15 minutes.
4
ENGLISH
Publicité
