Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
properly and perform its intended function. Check for alignment of moving
parts, binding of moving parts, breakage of parts, mountings, and other
conditions that may affect its operation. Inspect screws and tighten any that
are loose. Any part that is damaged should be properly repaired or replaced
by an authorized service centre unless otherwise indicated elsewhere in
the instruction manual. Have defective switches replaced by an authorized
service centre. Do not use the tool if switch does not turn it on and off
properly.
14.
REPLACEMENT PARTS. When servicing, use only identical replacement
parts.
15.
SERVICE AND REPAIRS should be made by qualified repair technicians at
an authorized repair centre. Improperly repaired tools could cause serious
shock or injury.
SAFETY INSTRUCTIONS FOR BATTERY AND CHARGER
1.
CHARGE BATTERY FOR AT LEAST 6 HOURS before initial use.
2.
CHARGE AT ROOM TEMPERATURE. Room temperature must be higher
than 0°C (32°F) and lower than 50°C (122°F).
3.
DO NOT CHARGE IF CHARGER'S CORD OR PLUG IS DAMAGED.
Charging with a damaged cord may result in fire or electrical shock. If charger
is damaged in any way, have it repaired by a qualified serviceman.
4.
DO NOT SHORT ACROSS TERMINALS OF BATTERY. Take care that
metal such as paper clips, nails, the sides of a metal tool box do not cause
a short in your battery. Extremely high temperatures and fire can result.
5.
DO NOT INCINERATE BATTERY
WARNING! The warnings, cautions, and instructions in this manual cannot cover
all possible conditions and situations that may occur. It must be understood
by the operator that COMMON SENSE AND CAUTION ARE FACTORS
THAT cannot be built into this product, but MUST BE SUPPLIED BY THE
OPERATOR.
SPECIFICATIONS
18V Cordless Drill
• Voltage: 18 volts DC
• Variable speed reversible trigger with electric brake
• No load speed: 0-600 RPM
• 3/8" (10 mm) keyless chuck
• 22 position clutch
Accessories Included:
•
2 double-ended screwdriver bits
6 drill bits
•
6 x 1" (25 mm) screwdriver bits
•
1 magnetic bit holder
•
1 - Charger: 3 to 5 Hour CUL & UL-Approved
2 - Batteries: 1.2 Ah Ni-Cd Rechargeable
14
CD15718
!
Publicité
