Bathroom Scales - SEVERIN PW 7010 Mode D'emploi

GB

Bathroom scales

Dear Customer,
Before using the appliance, please read the
following instructions carefully and keep this
manual for future reference. The appliance
must only be used by persons familiar with
these instructions.
Important safety instructions
∙ Warning: People fi tted with pacemakers
should consult their doctors before
using the appliance, as the pacemaker's
function may be affected.
∙ Do not expose the unit to rough handling
or jolting.
∙ Do not exceed the maximum load
capacity of 180 kg / 396 lb / 28 st. If it is
exceeded, the symbol 'Err' will appear in
the display.
∙ These bathroom scales are designed for
household use and are not suitable for
medical or commercial applications; the
unit is not offi cially calibrated.
Before using this unit for the fi rst time
Open the battery compartment and remove
the protective strip between the battery
terminals and connectors inside the unit.
Scales adjustment
∙ Before the scales are used for the fi rst
time, and also every time the unit has
been moved or placed on a different
surface, the scales need to be re-
adjusted:
∙ Briefl y step onto the scales to activate
them, and then step off again.
∙ The display shows 0.0; the scales
are ready for use once the display
6
disappears.
Changing the display format
∙ The display format can be selected in 'kg',
'lb' or 'st'. The switch for changing the
display format is located underneath the
unit.
∙ To change the display format, use the
key to switch the scales on, wait until
the display stops fl ashing and then use
the arrow keys (
desired format.
Display range:
5 kg - 180 kg
11 lb - 396 lb
0.79 - 28 st
General information
In order to get a clear indication of a
particular trend development, it is essential
to provide comparable measuring data.
Any measurements should therefore be
performed at the same time of the day, and
under similar conditions.
Operation
∙ Position the scales on a fi rm and level
surface. Using them on a soft, unstable or
uneven surface may result in unreliable
readings.
∙ The scales are designed to produce
correct readings only when the ambient
temperature is between 0 and 40 °C and
the relative humidity below 85%.
Storing personal data
∙ To show correct measuring data for the
body fat analysis, the data for height,
weight and gender must be selected
each time before any such analysis is
and ) to select the