Preparing Coffee After Generating Steam; Descaling - FrancisFrancis illy IPERESPRESSO X7.1 Manuel D'instructions

Press the steam button
least 3 seconds.
The machine will start dispensing
hot water; the steam button
"will fl ash rapidly.
Press the steam button again on reaching the desired
quantity of water.
PREPARING COFFEE AFTER GE-
NERATING STEAM
It is very important to avoid making coffee right after dispen-
sing steam because the water generated by the thermo block
is too hot and will impair the fl avor of the coffee.
For this reason the coffee button
thermo block temperature is too high.
To switch the machine back to the
coffee mode, press the coffee but-
ton and wait until the
lights up; during this cooling down
phase (approximately 10 minutes),
the cup icon in the central circle
will fl ash.
To switch the machine back to the coffee mode quickly (appro-
ximately 1 minute), carry out the following steps:
Place a metal pitcher beneath the
steam wand.
21
for at

DESCALING

The formation of limescale is a natural consequence of using
of the machine.
The machine features an automatic program designed to opti-
mise cleaning and remove limescale residues from inside the
machine.
Note: use only descaling products intended for coffee machi-
is disabled when the
nes.Please follow the procedure described below, not the in-
structions on the label of the descaling product.
button
Starting the procedure:
The
fl ash simultaneously to signal that the automatic descaling
cycle has been selected.
Keep the steam button
sed down for 3 seconds.
A programmed quantity of hot wa-
ter will be dispensed; the fl ow will
stop automatically.
If the icon in the central circle
fl ashes (1 fl ash every two seconds)
proceed as follows:
Keep the coffee button
steam button
together for at least 5 seconds.
and buttons and the
EN
pres-
and
pressed down
icon in the circle will