Brewing hot Water
Your brewer is able to produce hot water for making hot cocoa from a
packet, or for use in cooking, for making soups, etc. Simply follow the
instructions on page 7, "Ready To Brew Your First Cup" without adding a
K-Cup
pack.
NOTE: After brewing a hot cocoa K-Cup
®
running a hot water brew cycle without a K-Cup
Purging the Brewer
If your brewer has not been used for more than one week, you should purge
the water from the internal water tank.
If there is water in the Water Reservoir, remove the Lid, then lift the
1.
Water Reservoir straight up and away from brewer. Discard water, rinse
and refill with water. Place the Water Reservoir back on the brewer and
replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
2.
Be sure the brewer is turned 'ON'. Lift and lower the Handle on the brewer
without inserting a K-Cup
pack.
®
3.
The LCD Display will be in its idle state (fig. 4).
pack, we recommend
®
®
pack.
10
fig.
Place Mug,
Select
Brew Size
4 Oz.
6 Oz.
8 Oz.
10 Oz.
12 Oz.
9
Place a large mug on the drip tray and
4.
select Large Mug (10 oz. serving) brew size
from the Select Brew Size Menu (fig. 10).
Discard water.
5.
Repeat steps 2 - 5 two more times to
6.
completely purge water from the Internal
Hot Water Tank.