Extel eWatch Série Guide D'installation Rapide page 19

eWatch
Fill in the email and username fields. Click "code vérification" ("verification code"). You will receive
an email containing a 4-digit code. Enter this 4-digit code (warning: you only have 5 minutes to
enter this code). Enter a password twice (maximum of 6 characters).
Click "finaliser" ("finish") to create your account.
3 – Registering the camera
Connect the camera to the power supply. The camera should flash red. If not, press and hold the
reset button on the back of the camera for 5 seconds.
Warning: No user should already be registered on the camera.
Open the application and click Click "ajouter WIFI " ("add WI-FI")
The box to which the smartphone is connected
will appear. Enter the password for the box and then
click "connexion" ("connect").
The camera will beep and after 1 minute the camera's
serial number will appear. Click "ajouter" ("add") in
green. After a few seconds, "ajouter" ("add") will turn
grey.
The camera is ready to use.
CFI EXTEL eWatch - 04/2017
GB2