Metabo HPT UC 18YTSL Mode D'emploi page 10

English
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING:
1. Connect the multi port charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle, the charge indicator lamp will
blink in red. (At 1-second intervals).
2. Select the charging mode.
Select the charging mode to suit
requirements. (Fig. 2) (See "CHARGING
MODE SELECTION" on page 7.)
3. Insert the battery to the multi port charger.
Insert the battery into the multi port
charger as shown in Fig. 4.
NOTE:
The charging lamps next to each of the
four ports indicate the charging status of
the corresponding battery being charged.
10
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
WARNING:
Do not use the electrical cord if damaged. Have
it repaired immediately.
Charge
indicator lamp
Mode selector
switch
Electrical outlet
Battery
Plug
Charge indicator lamp
Guide rail
Fig. 4