Cleaning; After Every Use - Unitec SKF 025 Mode D'emploi

Cleaning

Replacing the reversing plate
Cleaning

After every use

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
42
When the reversing plate is completely worn, it must be replaced
by a new one:
Remove the fixing screw and remove the reversing plate.
‹
Insert the reversing plate and tighten the fastening screws
‹
again.
WARNING
► Switch off the machine and pull the plug out of the mains
socket before starting maintenance and cleaning.
► Due to the risk of injury to persons or damage to the ma-
chine, cleaning with compressed air is prohibited.
CAUTION
► Never immerse the machine in water or other liquids.
Remove swarf on the machine.
‹
Clean the tool on the underneath of the machine.
‹
Clean the guide rollers.
‹
Put the machine and accessories into the transport case.
‹
SKF 25