Transport Inspection; Setting Up; Safety Measures; Checking The Properties Of The Workpiece - Unitec SKF 025 Mode D'emploi

Before using for the first time
Before using for the first time

Transport inspection

Setting up

Safety measures

Checking the properties of the workpiece

CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
36
As standard, the machine is supplied with the components indicat-
ed in the "Components/delivery contents" section.
NOTE
► Check for visible signs of damage or missing items on
delivery. Report an incomplete or damaged delivery to your
supplier/retailer immediately.
This section contains important instructions on required prepara-
tion before starting setup work.
WARNING
Risk of injury from a falling machine.
Observe the following safety instructions to avoid any danger.
► The machine may only be operated in a horizontal position.
► Secure the workpiece.
The surface of the workpiece must meet the following require-
ments:
■ The surface must be smooth and may not have any burn
points, slag, welding joints or similar.
NOTE
► Before beginning with milling, remove surface unevenness.
SKF 25