Meister MOF1200-1 Traduction Du Manuel D'utilisation Original page 64

Fig. 4: Insert the shaft of the router
head (not included in the scope of deliv­
ery) into the collet (21) by approx.
3 / shaft length.
4
Fig. 5: Turn the router axle clockwise by
hand, at the same time pressing the
lock button (4). As soon as it engages:
Hold it down firmly and using an
open­ended spanner (23), tighten the
router chuck (16) firmly.
Set depth stop
It is recommended to set
the depth stop, if the router
head is to be plunged into
the surface of the work­
piece to a specified depth.
Fitting router head.
Move depth limiter to zero setting (see
Fig. 6).
Place router on the workpiece.
Fig. 7: Undo the locking lever (14).
Fig. 8: Undo locking screw (9). Allow
depth stop (10) to drop onto the depth
limiter (8).
Fig. 9: Push router down until the
router head rests on the surface of the
work. In this position tighten the locking
screw (9).
Fig. 10: Release router so that it moves
up again. The depth stop is now set to
0 mm cutting depth.
Loosen locking screw (9) and move
the depth stop (10) upwards to the
desired milling depth. Tighten the lock­
ing screw (9) in this position. The depth
64
5458010-Oberfraese-man.indd 64 5458010-Oberfraese-man.indd 64
stop is now adjusted to the desired
milling depth.
The cutting depth can be precisely
adjusted using the fine adjustment (11).
The set cutting depth applies only to the
currently fitted router head! If router
heads with a different geometry are
used, the depth stop must be reset.
Set cutting depth and lock
Risk of injury! Always unplug
from mains before setting!
It is recommended to lock
the cutting depth if routing
is to be done to a specified
depth over the whole length
of the workpiece, starting
at the front edge.
Fitting router head.
Set depth stop (see above).
Fig. 11: Place router on the edge of the
workpiece and press down until the
depth stop (10) rests on the depth
limiter (8).
Fig. 12: Lock at this setting with the
locking lever (14).
Setting the depth limiter (8) (Fig. 13)
The depth limiter enables the set dimen­
sion of the depth stop to be reduced.
Set depth stop (see above).
Connecting the chip extractor (Fig. 14)
To avoid inhaling harmful dust, always
work with the vacuum cleaner connect­
ed up! Any commercially available vacu­
09.12.20 06:39 09.12.20 06:39