Installation Custom Models - Indel Webasto Marine Isotherm DR70 Instructions Pour L'installation Et L'utilisation

4.2 Installation Custom models

Custom models with doors equipped for front panelling by the
customer (not supplied by Indel Webasto Marine Srl) are equipped with
2 side mounting brackets for installation.
Follow the instructions below for correct installation:
• Verify installation tolerances for panel application.
• Provide a door locking system to prevent accidental opening. Closure is not
included with supply.
• The refrigerator will be equipped with a mounting kit inside (Fig.5).
• Fasten the three brackets included in the kit on the panel (Fig.6), according to
the distances indicated in the diagrams (Fig.7-8-9).
• Affix the Custom panel to the refrigerator door and centre it horizontally and
vertically using the adjustments on the brackets (Fig.10-11).
• Insert the refrigerator in the compartment, positioning it so that the door panel
is flush with the rest of the unit and tighten the two side mounting brackets (Fig.
12).
• Cover the fastening points with the two plastic plaques provided in the mounting
kit.
56
User Manual