Fronius MTG 270i US-Style Instructions De Service page 41

Final tasks - Lincoln and Hobart:
5
Cut and deburr the inner liner 8 mm (0.315 inches) behind the previously marked position; ensure that no burr
protrudes into the inner liner
6
Screw the end cap onto the inner liner
8
Remove the mounting aid
- The welding torch can now be connected to a Lincoln / Hobart welding system. To
do so, see the Operating Instructions for the respective welding system.
- For information on connecting the control line, see the following section
ting the welding torch
7
Push the inner liner into the welding torch fully and
secure the end cap in the PowerPin
Connec-
41