Publicité
Les langues disponibles
Les langues disponibles
12) Controlling your house with home automation modules from X10
The 8in1 remote control allows you to command all electric appliances you have in your
house. In addition to transmitting infrared signals, which control your TV, VCR, SAT, CD,
DVD and CBL, your remote is equipped with a radio transmitter sending X10 signals, which
will enable you to control from a distance lamps and electric appliances. Here are some
examples that you can do with your 8 in 1 remote using X10
- Switch on/off , dim lights while you watch TV.
- Switch on the lights at night to frighten intruders when you detect something suspicious
- Switch on your electric blanket before the film ends to have it warm when you go to sleep
For controlling your lamps or appliances, you will need additional X10 home modules. The
modules are simply plugged into a/c outlet with no additional wiring required. Contact your
retailer for additional information.
To switch on/ off an appliance plugged into an X10 module : Press the X10 key (5),
then press the unit code of the X10 module on the key pad (10) and then press CHAN+ / - (14)
To dim/bright a light plugged into an X10 module : press its unit code on the key pad
(16) and then press VOL+ / - (16)
To turn ON all the X10 Lamp modules: Press the Power key (2)
To turn Off all the X10 modules (Lamp and appliance): press the Mute key (15)
13) Changing the X10 House Code
The preset house code is A and in the majority of cases it is not necessary to change this
setting except if there is interference from neighbouring X10 systems. In that case :
1- Press and hold SETUP (4) until the LED lights continuously
2- Release the SETUP (4) button
3- Use the digit keys (10) to enter the number equivalent to the chosen home code (1=A,
2=B, ... 16=P).
4- Press the ENT (11) to confirm your command. The LED will turn off
Note : The code you have chosen has to be the same as the one selected on the Transceiver
module TM13 or the security console, with which you use your remote.
14) Problems and troubleshooting
The remote doesn't work or looses codes entered :
· Confirm with your original remote that the equipment works correctly
· Make sure that you have pressed the corresponding mode key of the equipment or device
that you want to control.
· If the listed code does not work, try the AUTOSEARCH method or enter the next code of
that brand.
· To find the corresponding code for your equipment use the automatic search.
· Check that the batteries respect the polarity of the battery compartment.
· The programming of the remote requires 4 AAA batteries (new). If the remote looses codes
within a few days/weeks the problem can be solved by using 4 new batteries of the same
brand.
· If the LED is lit permanently, it will generally be necessary to replace the batteries.
:
11
:
Publicité
