Fuel Supply - Ferroli SUN M3 Mode D'emploi, Installation Et Entretien

2.3 Fuel supply

Gas circuit
THE BURNER WILL ONLY WORK WITH FERROLI GAS RAMPS.
Make the gas circuit as shown in the diagram in Fig. 4
The line to be prepared by the installer who, depending on the type of valve, must
ensure a supply pressure, according to the burner as given in the technical data
table (see section 4.3)
1 2
Key
1 Burner
2 Minimum gas pressure switch
3 Gas valve assembly
4 Filter
5 Vibration damping coupling
6 Manual shut-off cock
30
3 4
fig. 4
Cod. 3540G431 - 11/2007 (Rev. 00)
SUN M3 - M6
MANUFACTURER INSTALLER
5 6
EN