Publicité
Les langues disponibles
Les langues disponibles
WLAN and decoder control information:
A full locomotive decoder is installed in the event that the camera ICE is used on a digital
system.
The most important settings (CVs) at a glance:
CV1 = 3
(Digital address)
CV2 = 4
(Setting-off speed)
CV3 = 6
(Acceleration delay)
CV4 = 2
(Braking delay)
CV5 = 252 (Top speed)
CV6 = 85 (Mean speed)
CV160 = 1 (Digital or WLAN control setting)
Using CV160, it can be defined whether control commands are processed by the WLAN and/or
the digital system.
Setting options:
CV160 = 1 (Digital system commands to the point of the first WLAN command, then WLAN
commands)
CV160 = 2 (WLAN commands to the first digital command, then digital system commands)
CV160 = 3 (Only WLAN commands)
CV160 = 4 (Only digital system commands)
Programming commands (on the programming track) are always processed by the WLAN as
well as the digital system.
Profi tip: Instruction videos are available at www.z21.eu/en/Camera-locomotives/
Installation for you to learn more about the various Camera ICE operating modes
(operation/combination with Z21 or another digital system, host and slave mode,
video recording via PC tool).
8
8051248923 (Kameraanleitung ICE).indd 8
21.08.2015 13:58:57
Publicité
