Publicité
Les langues disponibles
Les langues disponibles
15. Remote commands
The data request is done by the sending of the character ASCII <?>, followed by <CR> (carriage return). The device
also answers in the same way during the detection of an impulse pedals/automaton.
The other commands are shown in the following table:
?
AOFF 0 / AOFF 1 / AOFF?
BAT?
ID ?
IN
KEY 0 / KEY 1 / KEY?
ECO 1 / ECO 0 / ECO?
LCAL?
LCAL DD.MM.[YY]YY
MM
NCAL?
Sends the displayed value
Deactivates/activates/status the automatic switch-off
Sends the status of the battery (BAT1=ok or BAT0=low)
Sends the device identification (SY306)
Activates the Inch unit
Locks/unlocks/status of keyboard (except data output)
Activate/deactivate/status of Bluetooth
Sends the date of the last calibration (DD.MM.YYYY)
Sets the date of the last calibration
Activates the millimeter unit
Sends the date of the next calibration (DD.MM.YYYY)
economic mode
®
20
Publicité
