Waterflex WR4 AIR Manuel D'utilisation page 8

Safety Precautions / Maintenance advices
For your safety, please read these instructions before use !
Assembly this product properly using original parts according to the installation instruction. Before assembly, inspect whether pac-
kages are in good condition and whether spare parts are complete in accordance with transport precautions and the list of spare
parts.
Prior to exercise, make sure equipment fasteners are in locking state.
Please place the exercise bike on a dry and flat ground.
Before starting any exercise, it is essential to consult your doctor. An excessive training or incorrectly executed may cause health
issues.
For sustainable use of your bike, please follow these instructions :
- Regularly check the pH of your pool water. It must be between 6.7 and 7.6.
- In case of water shock treatment, please get out the bike from water.
- Avoid placing the bike too close of run-back nozzle.
- Get out the bike from water after each use and rinse with clear water.
Please use the attached or other appropriate tools to assemble or repair the exercise bike.
Make necessary maintenance using original spare parts.
For your comfort and safety, adjust the bike pool according to your body.
This exercise bike is only for use by one person at one time.
Use this bike only for the purpose for which it was intended, that is sports practice exercises.
Children and disabled persons shall use the equipment in the presence of adults or healthy people.
The exercise bike has a maximum load of 150KGS.
WARNING
Check the pH of the water on each utilisations. The pH water should be between 6.7 and 7.6.
Any damages caused by a wrong pH balance cancel the warranty.
(For anodized aluminum, inox parts, and silicone parts)
The bike is made of anodized aluminium and marine quality AISI 316L stainless steel conforming to standard 2001/95/EC on the
general safety of products. Its anti-corrosion treatment makes it suitable for chlorinated water, seawater and thermal waters. It does
not require any special care in pH-controlled water (6.7 / 7.6).
Remove the bike after every use, rinse it with soft water, and wipe it.
Regularly check the pH of your swimming pool (pH 7.2 advisable)
Remove the bike during manual dosages of chemical products or impact treatments. Keep the bike away to avoid any splashes that
can stain or any deposits (due to the concentration of chemical products).
Deposits of powder, salt, corrosive products that encourage the corrosion process.
When first cleaning the surfaces of the swimming pool (before filling it) as well as subsequent maintenance cleaning, it is advised that
you remove the bike from the pool so as to avoid any risk of stains or deposits.
When you are not using the bike, it must be rinsed thoroughly with soft water, then dried and stored in a location away from chemical
products, as well as equipment used for dosing chemical products for pool maintenance.
If there are lime-scale deposits or stains, these can be removed with a cleaner for anodized aluminum and a non-abrasive soft cloth.
Then wash with clean water and dry it completely.
When you put the bike on the water, hold back the bike for prevent impact and damage to your pool or your bike.
8