Oase Trafo-Transformer Notice D'emploi page 9

Intended use
Only use the product described in this manual as follows:
• Only connect the product with units intended for this purpose by OASE.
• Operate the product in compliance with the technical data. (→ Technical data)
Symbols on the unit
Installation and connection
 B, C
• Position the transformer at least 2 m from the edge of the pond.
• Connect the plug of the consumer with the 3-fold distributor and hand-tighten its
cap nut.
• Cover unused outlets with the supplied protective caps. The protective caps protect
the connections against splash water. Ensure that the connections are never
placed or immersed in water.
• Have units without a power plug connected to the mains by a qualified electrician
according to the following table:
A = 0.75 mm
The unit is dust-tight and protected for short-term immersion.
Protection class II. The unit is securely disconnected from the
power supply by a reinforced or double insulation.
Safety disconnecting transformer. The primary and secondary side
of the transformer are electrically isolated.
Thermal fuse. Fusible cut-out tripped when the permissible oper-
ating temperature is exceeded.
Do not dispose of the unit with normal household waste.
Read the operating instructions.
U
Blue N
230 V AC
2
Brown L
EN
9