SCS Sentinel prim' OneGate 3 MCO0062 Notice D'utilisation Et D'installation page 33

Over current
7
setting
Open partially
8 (pedestrian
opening)
9 Pre-Flashing
Over current
A
reverse setting
Full open remote
switch
C
(on the remote
control)
Pedestrian open
remote switch
E
(on the remote
control)
7-0 4A
7-1 6A (fault)
7-2 8A
7-3 10A
7-4 12A
7-5 14A
7-6 16A
7-7 18A
7-8 20A
7-9 22A
8-1 10%
8-2 20%
8-3 30%
8-4 40%
8-5 50%
8-6 60%
The flashing light
9-0 blinks when the
gate starts to move
The flashing light
blinks 3 seconds
9-1
before the gate
starts to move
A-0 Stop
A-1 Reverse 1 second
A-2 Reverse 3 seconds
A-3 Reverse to the end
C-1 the top left button
C-2 the top right button
the bottom left
C-3
button
the bottom right
C-4
button
No function in
E-0
transmitter
E-1 the top left button
E-2 the top right button
the bottom left
E-3
button
the bottom right
E-3
button
The function can adjust the running
force of motor to be compatible with
the gate weight.
The factory setting is « 7-1 »
This function can adjust the time of
opening partially.
The factory setting is « 8-2 »
The factory setting is « 9-0 »
The factory setting is « A-3 » .
The reverse function only operates 3
times and then stops.
If gate reverses, the auto close
function will be cancelled.
The factory setting is « C-1 » .
The factory setting is « E-2 »
EN
33