SCS Sentinel prim' OneGate 3 MCO0062 Notice D'utilisation Et D'installation page 31

If your gate is opening when you start the programmation, stop the program to push on SET. L» appears on the
LED1
display, wait for it to turn off then go on the program 1 to reverse the rotation direction of your gate (see following
LED2
LED1
page).
LED3
LED2
LED3
1
1
Appuyer
1~3 Sec
ON
4
OFF
4
(2)To reset factory settings.
LED1
LED2
LED1
Press UP and DOWN for 3 seconds, and the LED display shows « CL ».
LED3
LED2
LED3
Push 1-3
Appuyer
3 secondes
1
1
LED Display
Push
Appuyer
Appuyer
2
Push 1-3
ON
Appuyer
sec
1~3 Sec
ON
OFF
OFF
5
Appuyer
3 secondes
sec
2
« -L » : the system learning is not done
« OP » : the system is in normal operation
To program, press SET button for 3 seconds. When the LED display changes from «
OP » to « 1 », press UP or DOWN to change the function settings (1 to P). Then press
SET to enter the sub function within each group, press UP or DOWN to select sub
functions and press SET to valid
« LE » : Enter the learning mode and then wait for learning instructions.
« LP » : the system learning is in process.
The auto-learning process of gate moving :
«Gate open to the end - stop close to the end - stop»
« CL » : Reset factory setting.
Appuyer
Push 3
3 Sec
Appuyer
sec
3 Sec
2
3
ON
OFF
5
6
2
Programmable functions
3
6
EN
31