Fm Mode; Aux Mode; Bluetooth Mode - ready2music aurora+ Mode D'emploi

FM MODE

FM radio mode receives analogue radio from the FM band (87.5-
108MHz) and display RDS (Radio Data System) information about
the station.
1. Fully extend the pigtail antenna.
2. Short press the button repeatedly to select FM mode.
/
3. Press and hold the /OK button for 3 seconds, the unit
will auto search from low-end frequency toward high-end
frequency and automatically save up all the stations with
strong signals in sequence. It will automatically play the No. 1
station saved once the auto searching is finished.
3. Press the /OK button to select the preset station in sequence
4. Press and hold the " " or "
will then stop automatically at the first station it finds.
5. Short press " " or " " button to tune the radio down or up in
50KHz steps for fine tuning.
Note: If the reception is too weak and there is noise on the
received station, try to improve the reception by changing the
position of the pigtail antenna.
Station Presets and Recall
The unit allows you to store up to 20 FM stations and recall them
in the same way as described in DAB mode.
36
" button to search the station, it
AUX-IN MODE
Aux In mode plays audio from an external source such as an MP3
player.
1. Plug one end of the 3.5mm audio cable (included) into the
headphone or line out jack on your player, plug the other end of
cable into the AUX-IN jack on the back of the unit.
2. Short press the button repeatedly to select AUX-IN
/
mode.
3. Turn on the external audio source and play your device.
4. The volume level can now be controlled through the main unit.
Operate all other functions on the external device as usual.
Notes:
1. If you're connected to the Line out Jack of your external device,
then you only need to adjust the volume control of this unit.
If you're connected to the Headphone Jack of your external
device, then you may need to adjust both the volume control of
your external device and the volume control of this unit to find
the most desirable volume setting.
2. Press and hold the / button to switch the unit to Standby
mode when you finish listening.
Don't forget to switch off the power of your external device as well.

BLUETOOTH MODE

This device offers you the possibility to use a Bluetooth enabled
device. The functional radius is limited to approx. 10 metres
depending on the surroundings and the unit used.
Due to the different device manufacturers, models, and software
versions, a full functionality cannot be guaranteed.
EN
37