CDVI KCINBT Mode D'emploi page 12

3] MOUNTING KIT 3] MOUNTING KIT
Varistor
KCIN
Remote
Controller
4] MOUNTING
1
Verify the distance between the KCIN
keypad and its remote
(Refer to page 3 «Notes
Recommendations»). Place the back
plate of the KCIN on the wall and the
bracket of the remote electronic then
mark with a pen the hole location then
drill the 2 mounting holes (drill bit
Ø 5 mm and 35 mm hole depth)
and the hole wiring access.
4
Fasten the KCIN keypad to the back
plate by using the supplied (M5x16)
Torx screw and T20 Trox spanner
®
hardware. Place the screw cap at the
bottom of the keypad.
12
KCINBT
Weatherproof Illuminated Keypad with remote electronics
(M5x16)
T20 Torx
Torx
®
Spanner
screw
- 1 1
1 - -
2
Insert the 2 plastic anchors in the
electronic holes. Place the back plate of the
and KCIN and screw on the wall using
the supplied
screws.
5
Insert the 2 plastic anchors in the ho-
les. Place the bracket of the electronic
and screw on the wall using the supplied
M4x30 screws. Slide the box from up
to down on the bracket.
(M4X30)
Plastic
®
Mounting
anchors
screws
2 2
2 2
(M4x30) mounting
Mounting
Wiring Wiring
plate for
sealed sealed remote
electronic
cap cap
box
- - -
2 2 1
3
Insert the cable in the hole access
area of the back plate. Then mount
the keypad on the back plate,
placing first the top in the hooks
and then the bottom.
6
(x4)
(x4)
Insert the cable in the remote electronic
and wire the cable to the terminals.
Do not forget to install the varistor
on the lock (Refer to page 3 «Notes
and Recommendations»).
EN
(x4)