Problem Solving - SCHUSTER S Série Mode D'emploi

ENGLISH

8 Problem Solving

Problem
Transfer press does not work after
pushing the start button
After the printing process started,
the heat element lowers but returns
immediately into is original
position.
Work plate is twisting
Reason
1. Compressed air pipe is not
connected.
2. Compressor is turned off
3. Pressure regulator is closed
4. Sliding table is not in end
position
5. Start buttons didn't get pushed at
the same time
6. Pushed emergency stop
Work plate was set up to low/ the
gap between heat element and
work plate is too big.
Height is not adjusted
insufficient locked in place.
- 16 -
Removal
Connect the compressed air pipe with the
compressed air filter (Ch. 3)
Turn on the compressor
Turn the pressure regulator to the left
(Ch. 4.2)
Push the sliding table until it blocks
(Ch.5)
Push the start buttons both at the same
time (Ch. 5)
Open the emergency stop
Raise the work plate, clearance max. 25
mm (Ch. 4.1)
or Arrange the work plate and lock the right
height adjustment through turning the clip
handle to the right - until the work plate is
not twistable anymore. (Ch. 4.1)
SM-54