Important - Duplex STANDARD Instructions D'utilisation Et D'entretien

When assembled the machine must look like the following drawing.
STANDARD
5. Adjust the screw of the register located underneath the lever (7) of the handgrip, at the same
time paying attention to the movement of the feelers (8) that allow the liquid to exit from the
tanks.
6. Make sure that the feelers (8) remain flush with the side panel when the lever (7) is not
pulled down.

IMPORTANT!

If the feelers protrude it may not be possible to insert or extract the tank
containing the liquid from their housings. Use a screwdriver on the feelers
to adjust their position either inwards or outwards.
STEAM
7
55
STEAM PLUS
DUPLEX 340-420-620
TEKNA
Figure 1.6
8
Figure 1.7