Indoba IND-70531-SGCE Instructions De Montage page 9

Assembly
CAUTION!
For your safety the screw heads should always
point outwards, otherwise there is a risk of
injury.
Only tighten all of the screw connections firmly
when you have finished assembly otherwise it
can result in undesired material stress.
1. Install the air vent (K) from the outside at
the pedestal front (H) using M5x10 bolt and
M5 lock nut. Screw the pedestals (G + H)
together with M5x10 screws and M5 nuts.
Note: All screws must be tightened firmly.
Insert the M5x10 bolt through the ventilation disc (K),
then slide the Ø13xØ6 washer onto the M5x10 bolt
from the rear. Now insert the bolt with the ventilation
disc (K) and washer through the front pedestal panel
(H). Slide the second Ø13xØ6 washer onto the M5x10
bolt from the inside and secure everything in place by
using an M5 lock nut.
2. Fix the pedestals (G + H) on the base (J) using
M5x10 bolts and M5 nuts.
3. Fasten fire bowl (F) to pedestals (G + H) using
M5x10 bolts and nuts M5.
Information for safe operation of the
barbecue
The barbecue must be positioned on a stable and
secure surface when it is in use.
Do not use in enclosed areas or on covered
areas.
Only use safe lighting materials (such
as solid firelighters).
4. Fasten wind shield (A) to the fire bowl (F) using
M5x10 bolts and nuts M5.
5. Place charcoal grid (D) into the fire bowl (F).
6. Insert ash catcher (I) into the pedestals (G + H).
7. Place cooking grill (B) into position of the
windshield (A).
WARNING!
The barbecue must be positioned on a stable
and secure surface when it is in use, otherwise
it may tip over.
The fuel container has a capacity of approx. 1,5 kg.
Before using the barbecue for the first time, it
should be heated with fuel (charcoal or briquet) for
approximately 30 minutes.
9