Publicité
Anleitung E-BS 800 SPK7
USE
The belt grinder/sander can be used to sand wood
and to grind iron, plastic and similar materials when
fitted with the correct grinding/sanding belt.
Layout
1
grinding/sanding plate
2
On/Off switch
3
locking button
4
additional handle
5
dust bag
6
connection for dust bag
7
clamping lever for grinding/sanding belt
8
grinding/sanding belt adjustment screw
9
Belt speed setting
Please read the directions for use carefully and
pay particular attention to the safety instructions.
Keep these operating instructions together with
the belt grinder/sander.
Technical data
Voltage
230 V~ 50 Hz
Power rating
Grinding/sanding belt dimensions
75 x 533 mm
Belt speed
360 m/min
Totally insulated
Sound pressure level LPA
88,8 dB(A)
Sound power level LWA
99,8 dB(A)
Vibration a w
8,112 m/s
Weight
Operating tips
Allow the belt grinder/sander to run up to speed
before you place it against the workpiece.
Do not switch off the belt grinder/sander while
the belt is still touching the workpiece.
Always hold the belt grinder/sander with both
hands during operation.
Always sand wood in the direction of the grain.
Important!
For health reasons it is essential to use the
dust bag!
Fitting the dust bag
Dust is drawn from directly above the grinding/
sanding belt into the dust bag.
21.11.2005
8:46 Uhr
Seite 5
Switching On/Off
Switching on:
Press operating switch 2
Continuous duty: Secure switch 2 in place with
locking button 3
Switching off:
Press briefly on operating
switch 2
The machine can be operated in momentary
action mode or in continuous duty mode.
Important!
Keep the air slits on the belt grinder/sander
clean and unobstructed at all times.
For optimal results with your belt
grinder/sander, use only original accessories
from ISC GmbH.
Changing the grinding/sanding paper
Pull the clamping lever (7) outwards to take the
tension off the grinding/sanding belt.
Pull the used grinding/sanding belt off the drive
rollers.
Slip the new grinding/sanding belt onto the drive
800 W
rollers.
Make sure that the running direction of the
grinding/sanding belt (arrows on the inside of the
grinding/sanding belt) are the same as the
II/®
running direction of the belt grinder/sander
(arrow on the rear drive roller).
Press back the clamping lever (7) to tension the
grinding/sanding belt.
2
Switch on the belt grinder/sander. Use the
3,4 kg
setting screw (8) to adjust the belt run so that the
grinding/sanding belt runs centrally on both drive
rollers.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
5
Publicité
