Installing Tilt Brackets - PEERLESS Mounts Smartmount D-FPT-220 Série Manuel D'installation

Installing Tilt Brackets

• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening
can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to screen or product may fail.
To prevent scratching the screen, set a cloth on a fl at, level surface that will support the weight of the screen. Place
2
screen face side down. Refer to screen manufacturers instructions or customer service, for removing any knobs,
base, cover or screw(s) on the back of the screen to prepare mounting. These need to be removed to allow the tilt
brackets to be attached. Select the small, medium, large or extra large screws from the baffl ed fastener pack then
attach tilt brackets to screen following fi gure 2.1 or 2.2.
NOTE: Top and bottom mounting holes on screen must be used for attaching brackets.
NOTE: Be sure to attach tilt brackets with handles facing outward as shown below. Verify that all holes are properly
aligned, and then tighten screws using a phillips screwdriver.
HANDLES
FACE OUT
CC
NOTE: For fl at back screens proceed to step 2-1. For bump-out or recessed back screen skip to step 2-2.
WARNING
CENTER BRACKETS VERTICALLY
ON BACK OF SCREEN
NOTE: "X" dimensions should be equal.
7 of 38
X
BB
X
ISSUED: 11-26-07 SHEET #: 202-9256-5 04-12-10