Bresser 7004040 Mode D'emploi page 7

SOFTWARE DOWNLOAD:
www.bresser.de/download/7004040
The software allows you to save and display your recor-
ded data. Install the software by following the setup
instructions and then start the software. Now connect
the device via the micro USB cable to your computer and
click on the USB icon [ ] in the software to establish
the connection.
When you click on „Set Time" the current time will auto-
matically sync and set on the device.
RECORDING AND RECEIVING DATA
Click on „Set Param" to enter the settings menu and set
parameters as appropriate.
Here you can choose two ways to record the data:
Method 1: Immediately
Method 2: Manual
12
Method 1: Immediately
This method is used when you record data while the
device is connected to your computer.
Choose the number of records and set an Interval.
Then choose „Immediately" and click on „OK" to begin
recording. „REC" fl ashes on the display. The fl ashing
frequency is the same as the record interval, indicating
that measurement of the instrument is carried out. The
data received can only be checked once the recording is
done. Click on „Stop Recording" and then click on „Data
Download" to save the recorded data. You can now open
the saved data fi le to see your recordings.
Method 2: Manual
This method allows you to take the device to a location,
record the data there, and then go back to your compu-
ter to download the recorded data from the device.
First connect the device to a computer and establish the
connection. Then click on „Set Param" to enter the settings
menu and set parameters as appropriate. Then choose
„Manual" and click on „OK". Unplug the device from the
computer and take it to the location where you want to
record the data. Press the „REC" button to start recording.
Press „REC" again, to stop the recording. After you bring
the device back and connect it with a computer, click on
„Data Download".
Note:
Each time you click on „Set Param", the previously
recorded data is overwritten. Therefore, please save
measurement data in time.
CLEANING AND MAINTENANCE
Before cleaning the device, disconnect it from the power
supply (disconnect ac power adapter)! Only use a dry cloth
to clean the exterior of the device. To avoid damaging the
electronics, do not use any cleaning fl uid.
DISPOSAL
Dispose of the packaging materials properly,
according to their type, such as paper or
cardboard. Contact your local waste-disposal
service or environmental authority for information on the
proper disposal.
Do not dispose of electronic devices in the
household garbage!
As per Directive 2002/96/EC of the European
Parliament on waste electrical and electronic
equipment and its adaptation into German law, used
electronic devices must be collected separately and
recycled in an environmentally friendly manner.
WARRANTY & SERVICE
The statutory warranty period is 2 years. We have
confi dence in our products, which is why we off er an
extended warranty on most. This is noted on the packaging
and begins on the day of purchase. To benefi t from this
extended voluntary warranty period, all you need to do is
register on the Internet. To register, visit www.bresser.de/
warranty. To claim the warranty, this registration must be
done within 3 months from the date of purchase (the date
of the purchase receipt is valid). If you register later, you
will lose the right to the extended warranty.
For complete warranty terms and services, please visit
www.bresser.de/warranty_terms.
EN
13