Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
DGLP60WLC
Hands-Free Proximity Card Reader - Wiegand
- Reinforced concrete walls.
- Any equipment not in conformity
with the EMC directive.
Optimisation
1. When the reader is installed in a position that could
present one the previously mentioned unfavourable
situations, a few simple actions can sometimes
improve the performance of the reader:
Try to analyse the environment to attempt
to identify one of the possible sources
of interference (radiation, metal, etc).
Check the connections and the wiring.
Check the voltage on the power supply
and the voltage on the terminal block on the reader.
Test the reader in a different configuration
from the one initially intended:
- Move the reader.
- Change its orientation.
Orientation :
% distance :
3] MOUNTING KIT
DGLP60 WLC
reader
30°
25°
0°
60%
80%
100%
ODIAX
tools
®
1
2.
If the reader works better in a different
configuration or position, it means
that the initial position is not optimal
and then should be changed until you find
the best configuration.
Note : Test the card reader with a 12V
battery and proceed to the installation.
3.
At start-up the DGLP60WLC reader perform an
auto calibration during 10 minutes to reach
optimal operation.
Using the badge
1. Present the badge with its face towards
the reader approaching slowly until the reading
signal is obtained.
2. It is not necessary to shake the badge
in front of the reader.
3. The badge should be presented
as parallel as possible to the reader
to optimize the reading distance.
Care : The more the badge is inclined
perpendicularly, the more the reading distance
will be reduced.
M5x42.5 DIAX
Sticker
screws
1
®
M5 metal plugs
4
4
cdvigroup.com
EN
3
Publicité
