Table des Matières
Publicité
•
Take the protection cap off the device before use.
•
Shift the on/off switch up (towards the shearing head) to switch on the device.
•
Use the trimmer on the back of the device to cut long hair.
•
Push the release button upwards until the trimmer comes off.
•
Run the shearing blade across the surface to be cut with the blade lying fl at against it to
remove the remaining hair.
•
After use switch the device off with the on/off switch and push the release button in until
the trimmer fi ts back into place.
Switch the device off with the on/off switch and pull out the plug.
•
Press the release button to remove the blade.
•
Clean the razor with the supplied cleaning brush. Attention: do not touch the blades of
the razor with your fi ngers!
•
In order to remove hair in the gaps of the blade, use the supplied brush.
•
Put the shearing blade back on after cleaning.
The workplace-related emission value is less than 70 dB(A).
Model: ...................................................................................................................... HR 2603 N
Power supply: ........................................................................................................ 230 V, 50 Hz
Power consumption: ..........................................................................................................1,0 W
Integrated battery: ..............................................................................................1,2 V, 500 mAh
Operation time: ......................................................................................................... 30 minutes
Maximum charging time: ................................................................................................8 hours
Protection class: .......................................................................................................................ΙΙ
Net weight: .................................................................................................................... 0,32 kg
This device has been tested according to all relevant current CE guidelines, such as
electromagnetic compatibility and low voltage directives, and has been constructed in
accordance with the latest safety regulations.
Subject to technical changes without prior notice!
05-HR 2603 N New.indd 39
05-HR 2603 N New.indd 39
Use
Cleaning and care
Noise development
Technical Data
GB
39
09.07.2008 14:08:29 Uhr
09.07.2008 14:08:29 Uhr
Publicité
Table des Matières
