Runpotec RUNPOCAM RC2 Notice D'emploi page 13

INTRODUCTION
RUNPOTEC appreciates your purchase of a RUNPOCAM RC2. These
instructions for use provide information on safe use of your RUNPOCAM
RC2. Read the instructions for use thoroughly before commissioning. If
you have any questions about commissioning, assembly, safety and
applications, or problems, please contact your dealer or RUNPOTEC by
telephone or e-mail. You will find our contact data on page 2.
SAFETY INFORMATION
Read the safety information on www.runpotec.com before use. The
RUNPOCAM RC2 is used exclusively for the exploration and inspection
of inaccessible components such as pipelines, hollow systems,
ventilation systems, etc. No liability is accepted for any other use!
No liability is accepted for any other use!
COMMISSIONING
Insert the Micro Memory
Card into the slot at the
side. If necessary, format
the card, see operating
instructions.
INSTRUCTIONS FOR USE
General
Photo/video
mode
RUNPOTEC GmbH – Irlachstrasse 31 – A-5303 Thalgau
Tel.: +43-6235-20 335 – Fax: DW 35 – office@runpotec.com
1
Camera head cable
connect with monitor.
Press and hold for 1,5 seconds to switch on and off
Rotate monitor image 180°.
Switch camera LED light on and off.
Adjust monitor brightness in 3 levels.
Press and hold for 3 seconds to switch to Capture
mode or to switch between Photo/Video mode.
Display top: Mode Photo/Video icon, battery status,
memory card, date, time.
Briefl y press to switch to the corresponding mode,
take a photo or start and stop video recording
(recording time is displayed in the upper right-hand
corner). File is stored in the archive.
ENGLISH
2
The Li-Ion battery is charged!
Monitor can be used imme-
diately. Charge the battery
with the Micro USB charging
cable and charging adapter.
S T R O N G E S T C A B L E P U L L I N G
13
3
