Before using your thermoelectric cellar:
Remove the exterior and interior packing
-Check to be sure the following parts are included:
9 slide out shelves
-Before connecting the appliance to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
-Clean the interior surface with lukewarm water using a soft cloth.
-Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded. To level your appliance, adjust the front legs at the bottom of the appliance.
-For recedes installation away from direct sunlight and sources of heat (stove, heater,
radiator, etc.).Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold or hot ambient temperatures may also cause the
appliances not to perform properly.
-Not designed for placement in adage or basement.
-The appliance is for indoor use only.
Caution: Please keep the appliance away from substance, which can cause ignition.
VI Electrical Connection
WARNING :
Improper use of the grounded plug can result in the risk of electrical shock. If
the power cord is damaged, have it replaced by an authorized Products service center.
This unit should be properly grounded for your safety. The power cord of this unit is
equipped with a 2-pin plug which mates with 2-pin wall outlets to minimize the possibility of
electrical shock. Do not under any circumstances cut or remove the ground wire from the
power cord supplied.
Use of extension cords is not recommended.
This unit requires a standard 120V-60HZ electrical outlet with 2-pin plug.
The cord should be secured behind the thermoelectric cellar and not let exposed or
dangling to prevent accidental injury.
VII Operating Your Thermoelectric Cellar
It is recommended that you installed the thermoelectric cellar in a place where the ambient
temperature is between 61-90°F. If the ambient temperature is above or below