Transport And Storage - Graf ECO BLOC INSPECT 230 Notice D'installation

4.

Transport and storage

4.1 Transport and storage
GRAF EcoBloc Inspect 230 system elements are packaged in a project-specific manner. The individual
parts of the EcoBloc Inspect 230 elements (module and baseplate) are usually located on Euro pallets.
The individual parts then have to be assembled on site.
The GRAF EcoBloc Inspect 230 elements can be transported to the installation location with a fork lift
truck or similar equipment. At the installation location, the EcoBloc Inspect 230 elements and ground
plates can be moved manually or with light-duty equipment.
A level & stable surface should be used for intermediate storage. Storage outdoors should not be for any
longer than one year. The impact sensitivity of the elements also increases as temperature falls. In
particular, impact during frosty weather could damage the elements.
Before installation, the EcoBloc Inspect 230 and ground plates should be checked for damage.
Damaged or defective blocks must not be installed!
4. Transport and storage
20 / 60