LaserLiner SensoPilot Pro Mode D'emploi page 10

SensoPilot Pro
Operation of remote display
Power supply
• In the case of battery operation, power is supplied from the SensoPilot.
• For operation from the battery of the construction machine, connect the remote
display (13) using the 12/24V battery cable, ensuring that RED is connected to the
positive battery pole (+) and BLACK to earth (engine block). The SensoPilot is then
also supplied with power via the connection cable - see illustration below.
Use of the remote display
The remote display allows laser reception of the SensoPilot to be monitored when
this cannot be seen from the cab of the construction machine. In this case, connect
the remote display (12) to the SensoPilot (4) using the connection cable and install
the remote display in the operator's cab.
Technical data
Laser reception range
Precision HIGH
Precision LOW
Battery / laser
Battery operating time / Charging time
Working temperature
Dimensions
Weight of SensoPilot / remote display
Subject to change
10
4
Connection cable from
SensoPilot to remote display
ENGLISH
12 13
12/24 V battery cable
200 m
+ 2 mm – + 5 mm
+ 5 mm – + 15 mm
7,2 V NiMh / 2500 mA
approx. 40 hours / approx. 15 hours
-20°C – +50°C
390 x 170 x 85 mm
3,4 kg / 1,1 kg
01.2005